Power Specifications 
    Output Power (per channel): 
    Continuous Average Output Power Both Channels Driven: 
    8 ohms, 20Hz - 20kHz, 0.1% THD: 400 watts 
    4 ohms, 20Hz - 20kHz, 0.1% THD: 600 watts 
    Continuous Average Output Power Bridge Mono Operation:
    16 ohms, 20Hz - 20kHz, 0.1% THD: 800 watts 
    8 ohms, 20Hz - 20kHz, 0.1% THD: 1200 watts 


    General Specifications
    Voltage Gain (dB):  35 
    Sensitivity (for rated power @ 8 ohms): 1.00 Vrms 
    Distortion: SMPTE-IM, Less than 0.05% 
    Dynamic Headroom: 3dB at 4 ohms 
    Frequency Response: 20Hz to 20kHz, +/-0.1dB; 8Hz to 100kHz, +0/-3dB
    Damping Factor: Greater than 200 
    Noise: 100dB below rated output (20Hz to 20 kHz) 
    Input Impedance: 20k ohms balanced and 10k unbalanced 
    Controls: Front: AC Switch. Ch.1 and Ch.2 Gain Knobs (with 2dB detents). Rear: Parallel/Stereo/Bridge Switch 
    PWR-ON: Green LED. LEVEL -30: Yellow LED. LEVEL -10: Yellow LED. LIM-CLIP: Red LED. TEMP-PROT: Red LED (flashes for over-temp) 
    Connectors (each channel): Input: Barrier Strip and XLR. Output: "Touch proof" binding posts, Neutrik "Speakon" connectors. 
    Cooling: Continuously variable speed fan, rear-to-front air flow. 
    Amplifier Protection: Full short circuit, thermal, open circuit, ultrasonic, and RF protection. Stable into reactive or mismatched loads. 
    Load Protection: On/off muting. Clip Limiting. DC-fault load grounding relay with internal fault fuses. 
    Output Circuit Type: Complimentary linear outputs. 2-step high efficiency circuit. 
    Power Requirements: 100, 120, 240 VAC, 50-60Hz 
    Dimensions: Faceplate Width: Standard 19" (48.3cm) Rack Mounting. Faceplate Height: 3.5"(8.9cm). Chassis Depth: 17.9" (45.5cm)
    Weight: Shipping (lbs/kg): 52/23.6 ; Net (lbs/kg): 44/20

    *Specifications subject to change without notice